Overview: QG Series Pulse Air Flow Dryer is a large quantity production drier, it adopt instant drying principle, utilize hot air’s quick move to drive damp raw material and make it oats in the hot a ir, this can strengthen the whole drying process,improve the speed of hot exchange. If raw material is dried by this equipment,non-combined moisture can be removed completely, dried material never metamorphosed, compared with general drier, output is remarkably raised.

Overview: The JG Series Airflow Dryer can rapidly remove moisture from the granules or powder that is easy to dehydrate (mainly water in surface). Because of the raw material stayed in the dryer only for a short time so the quality of finished products can be controlled to the best conditions. Our factory developed a reinforced device with stepless speed exchange based on basic dryer. When the wet raw material is fed through screw feeder, it will be fully mixed with hot airflow and the rotating knives will crush it into fine granule. The granule dries during the movement to the outlet and it finally enters the drying pipe under absorbing of air force. The humidity and heavy granule that is not absorbing of air force. At the place it is dried further. The humidity and heavy granule that is not absorbed by air will be continuously crushed and dried until it entering the drying pipe.

Overview: The drying process of FG Series Airflow Dryer is divided into two steps.First step: Utilize the tail air from second grade drying and mix with the supplemental hot air to process the first grade drying under positive pressure. The waste wet air will be exhaust out after reused. Second step: Use fresh air to process the second drying under negative pressure. The finished product will be measured and packaged. The high temperature and low moisture tail air is used for the first grade drying which creates a complete circulation process. The supplementary hot air may be adjusted freely.